Reunel Fit and Finish?
#1
Registered User
Thread Starter
Join Date: Dec 2002
Location: Cincinnati, OH
Posts: 551
Likes: 0
Received 0 Likes
on
0 Posts
Reunel Fit and Finish?
Everyone, I've been looking at the Reunel bumpers and was curious how the fit and finish is? How about customer service? If you have one (front or rear), please post your experience with 'em. Thanks!
Chris
Chris
#2
Registered User
Join Date: Feb 2002
Location: Sturbridge, Taxachusetts
Posts: 1,424
Likes: 0
Received 0 Likes
on
0 Posts
I have a rear. It's extremely stout, almost to the point of being rediculous. I needed a floor jack to lift it into place. The fit? It didn't. One of the mounting holes were slightly misaligned. Customer Service? Good, they sent me a reamer to open the hole slightly, but offered to have the bumper picked up at no charge and returned to CA (from MA). Finish, one word. Sucks. There is no paint on the backside of the bumper so it rusts quickly. There are several unwelded seams that allow the rust to weep thru to the front causing staining. I would recommend caulking the entire inside of the bumper and giving it a shot of paint before application.
#3
Registered User
Thread Starter
Join Date: Dec 2002
Location: Cincinnati, OH
Posts: 551
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the input, Commatoze. I guess I could see if they can ship them unpainted. That would give us a chance to touch up any welds before Linexing or powdercoating it. Thanks!
Chris
Chris
Thread
Thread Starter
Forum
Replies
Last Post
BrokeSolid
3rd Gen High Performance and Accessories (5.9L Only)
5
02-18-2010 02:34 PM
GO 4LO
Performance and Accessories 2nd gen only
13
07-19-2003 08:21 AM