Red3quarter

I was driving this morning to a friends. I stopped about a mile after leaving my house to get a pop from the gas station. The XZT was working yet because of the cold protection.

Get down the road a little and its now on, truck reached 140. 10 miles later I got in the throttle to pass a car and no go. Truck was back to driving like it was in stock mode but the switch was not in the stock position. Truck still drove fine, no problems with drivability but the quad wasn't working. While driving it flipped the switch a few times to see if it did anything and still stay in the off mode.

Get to my friends and let it sit for an hour or 2, I get back in to go home and now its working perfect again. I checked all my codes just be sure and nothing showed up.

Anyone else have this happen with a Quad XZT? I've had it a year with no problems. I wonder if i should reload the progaming in it?

Fern

On my adrenaline my monitor goes out every so often but the power level is still there. I've had to reload it a few times to get it up and running again. Thinking about sending it in for service.

Red3quarter

I don't have a monitor like your Adr does. Mine just lost all the extra HP during that drive. I even checked the connections and everything was good. Maybe sending it to quad wouldn't be a bad idea too.

Fern

At times I believe the power went off too. But I couldn't be sure cause I had it on level 1 or 2. Maybe the heat from the engine.

DodgeRamdiese01

I have a adren. and it lights up but has no power at all the things have problems all over the place all I got from the tech is that I probably hooked it up wrong,

Red3quarter

My xzt is mounted in the cab, so I know its not heat on mine.

XZT has worked fine for a year then just the other it did that. Has been fine last night and today. Think i'll wait to see if it acts up again, if it does then maybe I'll get in contact with quadzilla. As long as its working fine now I'll be happy.

Fern

I've been thinking about moving mine but going through the hassle of lengthening the wiring I'm not sure if I want to cut and splice anything voiding the warranty.