map and can connector?
#18
Registered User
Thread Starter
Join Date: May 2007
Location: West Tennessee
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
i think i found the map....do i just disconnect it and put the ts in between the stock connections?....still having trouble finding hte CAN....
#21
Registered User
On my 2001 the CAN bus was on the LP bracket. The MAP sensor is high on the block on the driver's side. Usually the box goes between the MAP sensor and the harness...so you unplug the harness from the MAP...plug in the box...plug the harness into the MAP connector on the box. Then plug the box into the CAN.
#23
Registered User
Thread Starter
Join Date: May 2007
Location: West Tennessee
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
the map is easy right? if its what i think it is, you can see it just looking down on the motor just under the intake manifold? right behind the filter housing?
#24
Registered User
Thread Starter
Join Date: May 2007
Location: West Tennessee
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
cstroup, do you think you could run out and take a pic of where your harness goes? this thing is making me mad....i have to run a few errands but ill be back shortly and i hope ya'll have some responses for me thanks alot guys!
hunter
hunter
#25
Registered User
Join Date: Jun 2007
Location: Grainfield, Kansas
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Mine was just hanging there
on dads it was fastened to the bracket and harder to see
also a picture of the adjust **** and 4 gauge pillar
SORRY for the Kansas dash dust
The red is pointing to the CAN the map is upper left corner
on dads it was fastened to the bracket and harder to see
also a picture of the adjust **** and 4 gauge pillar
SORRY for the Kansas dash dust
The red is pointing to the CAN the map is upper left corner
#26
Registered User
Join Date: Apr 2004
Location: Maine
Posts: 1,117
Likes: 0
Received 0 Likes
on
0 Posts
The fist picture he put up was of the map sensor, yours will have different style plugs cause yours is and 02 and his is an 01. Deff disconnect your battery, or you will throw a CEL. Dont tape your map plug, your new box is going to splice in between the factory connection. YOu will plug one end of your wiring harness that came with your box into the block, then the other end of the box wiring harness will plug into the stock wiring harness. Do not leave any of the map senosr connectors unplugged.
#29
Registered User
Thread Starter
Join Date: May 2007
Location: West Tennessee
Posts: 325
Likes: 0
Received 0 Likes
on
0 Posts
ya it said it was supposed to include some grease but mine didnt.....sweet switch location by the way.....havent decided what i want to do with mine yet....so could the can actually be fastened to the lift pump bracket? havent started lookin again cuz i got mad haha