kdp jig (Infidel)
#1
DTR's Toad Wrangler
Thread Starter
Join Date: May 2005
Location: N 48 25.707 W123 21.887
Posts: 892
Likes: 0
Received 0 Likes
on
0 Posts
kdp jig (Infidel)
Infidel I was just looking at your kdp jig in your gallery. I changed mine the hard way. But that jig is just a good looking unit. Wished I had of seen that before I repaired mine. But to make one I guess one would need the cover off to get the right measuerments. By the look of the jig I don't think you would even get your hands dirty and probably under an hour to complete. Nice piece of work.
#2
Registered User
It's not my work, and you are about right, 45 minutes to assure the dowel pin stays were it's supposed to.
The jigs are available from Harold for less than the cost of the crank seal.
Harold's email address is rvhvnfn@juno.com phone 208 850-8749
The jigs are available from Harold for less than the cost of the crank seal.
Harold's email address is rvhvnfn@juno.com phone 208 850-8749
Thread
Thread Starter
Forum
Replies
Last Post