edge attitude
#16
Administrator/Jarhead
#17
Registered User
Installing the pyro is pretty easy if you have the right tap. There are pros and cons either way to drill the hole, but I just had the truck running at idle and drilled away. Pieces are blown out the exhaust, no problem. Make sure you drill in the right spot so you get a good point for the pyro pickup. Honestly, that's the hardest part installing the Edge....
madhat, I was in -211 for about 6 years in Yuma.... It wasn't hell, but I could see it from my backyard....
madhat, I was in -211 for about 6 years in Yuma.... It wasn't hell, but I could see it from my backyard....
#18
Administrator/Jarhead
Yep. You just have to have the right size. The big deal about it, the shavings could fall into the turbo, and mess it up.
Some leave the truck running, some shut it off and use grease and a magnet, some drop the turbo off the manifold and tape over the flange.
Some leave the truck running, some shut it off and use grease and a magnet, some drop the turbo off the manifold and tape over the flange.
#19
Administrator/Jarhead
Oh, yeah, don't drill right in the middle of the collector, drill closer to the back of the manifold. There is a internal support in the middle of the collector.
#20
Registered User
Sorry about not clarifying that. You have to remove the shavings somehow. I did it by drilling with the engine running at idle. I think I put mine a little in front of the center divider of the manifold.
Yuma: all beach, no ocean....
Yuma: all beach, no ocean....
#21
Registered User
#22
Administrator/Jarhead
Here is where I have mine... They are the two silver things forward of the collector. I am not pointing at them... (takin a pic for something else.)
I assume that's what you wanted pictures of.
I assume that's what you wanted pictures of.
#26
Registered User
Join Date: Apr 2009
Location: kewaskum WI
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Installing the pyro is pretty easy if you have the right tap. There are pros and cons either way to drill the hole, but I just had the truck running at idle and drilled away. Pieces are blown out the exhaust, no problem. Make sure you drill in the right spot so you get a good point for the pyro pickup. Honestly, that's the hardest part installing the Edge....
madhat, I was in -211 for about 6 years in Yuma.... It wasn't hell, but I could see it from my backyard....
madhat, I was in -211 for about 6 years in Yuma.... It wasn't hell, but I could see it from my backyard....
Thread
Thread Starter
Forum
Replies
Last Post
blue2002
Performance and Accessories 2nd gen only
12
11-24-2010 11:46 AM
chrismez
3rd Gen High Performance and Accessories (5.9L Only)
3
09-26-2005 01:47 PM
Hoss
3rd Gen High Performance and Accessories (5.9L Only)
13
06-18-2004 06:14 PM