98rambaby

So I hit the dyno at Fast Specialties in Vancouver today. The first time I went with 50 horse jammers and a superchip and did 278 and 643. This time with everything in my sig. and did 525 hp and 1113 ft-lb`s, I am so happy didn`t think I would be near those numbers was figuring 450-480 for hp. What a birthday gift seeing as it is my birthday today.

Doj Dewd

those number are pretty high for what is in your sig. i have almost the same setup powerwise and you blew me out of the water by 90 horse! what did you dyno on? when i dyno'd most everyone else who ran thought their numbers were fair, or maybe just a hair low.

i will be dyno'in again tomorrow on what i think is a mustang dyno. keep you eyes open for the results in a thread somewhere . . .

i would ecstatic if i did your numbers . . . but i don't think it'll happen.

98rambaby

The dyno I was on was a mustang dyno

DragonSlayer

NICE! I need to get that power level outa my 12v!!!

HOHN

what was the uncorrected number?

SAE correction should not be applied to turbodiesels.

jmo

Doj Dewd

well i just did 465/1055 yesterday. still seems a bit generous to me . . . this is the corrected number (i think my uncorrected was approx 435)

just by adding numbers roughly
stock: 215
mach 2's: 105
TST-PM3: 120
right here we have 440. in my setup i still have a SMARTY, TS-MVP, CAI, 4" TBE to add on top, but the gains would be minimal i think (on top of what is listed above) - PLUS - we still have to account for drivetrain loss. i was happy with my numbers, as i seem to be right where i should be . ..

98rambaby

Nice, those are good numbers too.

John_P

Congratulations! Those are some good numbers.

--------
John_P

Joe Diesel

elevation has alot to do with the numbers too.