AutoMeter 3 Gauge Center Dash Pod
#1
Registered User
Thread Starter
AutoMeter 3 Gauge Center Dash Pod
Anyone installed one of these pods? I want to move my FP gauge off the steering column and add Oil temp & Rear End Gearlube Temp gauges. Do I need to remove dash? Where to route Mechanical fuel pressure line?
Anyone been there and done that?
Anyone been there and done that?
#2
Registered User
Join Date: Oct 2003
Location: NE Pa.
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
I ran my lines along the bottom of the windshield and tucked them between the
windshield and the dash.All the lines came up under the dash on the drivers side.
no drilling or removing the dash . I nothched a hole in the back of the pod so it sits right. I have a pic in my gallery
windshield and the dash.All the lines came up under the dash on the drivers side.
no drilling or removing the dash . I nothched a hole in the back of the pod so it sits right. I have a pic in my gallery
#3
Registered User
Thread Starter
Thanks! Notching the hole in the pod will solve my problem. Last night I loosened the dash just enough to drill a hole for lines (want them out of sight) but had problem of pod sitting flat due to braided fuel line.
Thread
Thread Starter
Forum
Replies
Last Post
randallp84
3rd Gen High Performance and Accessories (5.9L Only)
7
02-28-2009 04:35 PM
O.T
3rd Gen High Performance and Accessories (5.9L Only)
7
06-22-2007 11:38 PM
6 Shaker
3rd Gen High Performance and Accessories (5.9L Only)
4
05-03-2007 03:34 PM
jon05ctd
3rd Gen High Performance and Accessories (5.9L Only)
1
09-05-2006 08:39 PM