Any one try PDR's S300 based turbo's?
#1
Registered User
Thread Starter
Join Date: Jun 2006
Location: Republic of Alberta
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
Any one try PDR's S300 based turbo's?
I just ordered one of these baby's up. I got the 62-14. PDR has them built by an outside supplyer. I think they have been carring them for a little while now. Never hear much about them, anyone got one? Shold be like a Phat Shaft or HTB2......I hope.
#3
Registered User
Join Date: Aug 2005
Location: fredericksburg, virginia
Posts: 3,465
Likes: 0
Received 0 Likes
on
0 Posts
Maybe htt or II is the outside supplier? I believe there are a lot of shared parts in the s300 based lineups. 62/14 is a bit bigger than the super b.
#5
Registered User
Thread Starter
Join Date: Jun 2006
Location: Republic of Alberta
Posts: 106
Likes: 0
Received 0 Likes
on
0 Posts
With the new "Super High flow" (taper cut) DV's from Piers there is LOTs of fuel avalible if I slide my plate forwards. Unfortunatly I have never even seen a PS or HTT so I will not be able to make a fair comparison of how well the turbo puts out.
The supplyer is Not HTT, II or any other large name brand. I guess Piers stopped carring the BD turbo's in favor of this new supplyer due to cost (in Canada), as these ones are comparable (apparently).
The supplyer is Not HTT, II or any other large name brand. I guess Piers stopped carring the BD turbo's in favor of this new supplyer due to cost (in Canada), as these ones are comparable (apparently).
Thread
Thread Starter
Forum
Replies
Last Post
92smokin blacky
1st Gen. Ram - All Topics
2
02-25-2012 10:30 PM
Txwelder
Performance and Accessories 2nd gen only
14
11-11-2007 04:28 PM