Are we still on for the 20th???

My Xmonitor came in the other day, going to paint it tonight or tomorrow (depends on the weather). Should have the unit installed this weekend (boost and tranny temp) but need some help with the pryo. I don't want to try this one by myself, would like to have someone that has done this a time or two to lend a hand.

 

How do we get to Tims? Where is he located?

 

My shop is in Norfolk. It is off I-264 get off on Ballentine exit go 3 lights to Va beach blvd then right, go over the overpass and right on Scott st , 2 blocks down on the right. I need to get a rough count on who all will be there if we can. Tim

 

Hey Tim,
I'm just about 98% sure that I'll be there. I'll be getting off work at 0800 unless I decide not to work that day, in which case I'll leave the house in order to get down there as early as you want me.
I'll send you a PM concerning getting a few pointers from you on setting the line psi up a bit when I change my tranny fluid.

 

Unless something bad comes up (earthquake, flood, of famine) I'll be there.

 

I'm there. Ready, willing and able to learn how to drill for a pryo.

Hope we can get it done....

 

Don't worry Butch, if Tim's busy I'll help. I'll bring a drill and a 4 lb hammer, dead blow of course. We'll getter dun!

Chris

 

Cool...

Anything else I need to bring (besides all the parts )?

I think the pyro is 1/4" but it looks big to me, I'll have to measure it to make sure. Do you or Tim have the bits and taps or do I need to get a set? I have a tube of grease I can bring also. I know I don't have any antisieze, should I try to get some?

Anything else?

 

Butchera see what size you need for sure I still have the one I used when I did mine. If you need it I'll bring it.

 

Butch I have most every tap you will need as well as anti sieze. Chris if all else fails I have my mig welder Tim

 

Cool....

Then I guess I'll bring some frosty beverages for AFTER we get done. What's your flavor????

 

Yeah, I'm trying to think if there is ANY tool I should bring. I just can't think of anything Tim doesn't have. I do like to work out of my own box when possible though, cause I know where everything is.
For those of you who haven't been to the shop, it's an eye opener. OK, he might not have a diesel injector tester, but how often does anyone needs one of those?

Butch, you got all the wire you'll need, and the fuse taps (or other, depending on where you plan to extract power from), and the wire conduit? That's all I can think of.

I'lll be calling the new recruits here in Richmond tomorrow to see how many of them want to come down on the 20th.

Chris

 

Maybe I should call these guys,,,,,,,,,,,,,

They seem to have done a great job the last time there was wrenching going on!

 

Who's the bum on the right?

 

The thing is installed (except for the pryo). Everything is run, all the wires are in and it even works...

Now all that is left is the pryo.

Tim, I went on a recon mission to find your shop. Is it the one in the back of the fire protection place? If not, I missed it. What is the street address?

Anyway, see ya'll next weekend....