HX35 flange
#1
Registered User
Thread Starter
HX35 flange
For those of us with late HX35s that have the integral cast elbow, here's a little project I did.
I got some 3/8" flatbar 5" wide at the local Metal Supermarket. 6" would have been better though.
I chopped off the flange from my old/stock downpipe and got to work. 8)
I sure do hope it fits
I got some 3/8" flatbar 5" wide at the local Metal Supermarket. 6" would have been better though.
I chopped off the flange from my old/stock downpipe and got to work. 8)
I sure do hope it fits
#4
Registered User
very nice work and a great idea for everybody
you should heat it in the barbeque's for an hour get her nice and hot and while hot weld up the inside so it doesn't crack on your outside weld later cause it will otherwise . not at first but given time it will found out the hard way racing turbos in the eighties .
you should heat it in the barbeque's for an hour get her nice and hot and while hot weld up the inside so it doesn't crack on your outside weld later cause it will otherwise . not at first but given time it will found out the hard way racing turbos in the eighties .
#6
Registered User
wow the granolas dont hassle you about your hot rod oil burner? last time at mayne on the way to the buddys
house I took the truck instead of the ricer , and some granny gave me grief about the little puff at start up, nice work by the way.
house I took the truck instead of the ricer , and some granny gave me grief about the little puff at start up, nice work by the way.
#7
Registered User
Thread Starter
still not in if weather is good tomorrow its going in
Trending Topics
#10
Registered User
Thread Starter
I ran it yesterday
Feels good. My black cloud is gone and it pulls harder
I could have tightened the oil return tube a bit better... I had an oily surprise when I checked on things at the beer store.
Feels good. My black cloud is gone and it pulls harder
I could have tightened the oil return tube a bit better... I had an oily surprise when I checked on things at the beer store.
#11
Registered User
We call people like that(All ages) moonbats, here
#12
For those of us with late HX35s that have the integral cast elbow, here's a little project I did.
I got some 3/8" flatbar 5" wide at the local Metal Supermarket. 6" would have been better though.
I chopped off the flange from my old/stock downpipe and got to work. 8)
I sure do hope it fits
I got some 3/8" flatbar 5" wide at the local Metal Supermarket. 6" would have been better though.
I chopped off the flange from my old/stock downpipe and got to work. 8)
I sure do hope it fits
Thread
Thread Starter
Forum
Replies
Last Post
vwjunkie53
1st Gen. Ram - All Topics
5
02-11-2010 11:50 AM