Trans temp porb
#1
Registered User
Thread Starter
Join Date: Dec 2006
Location: New Jersey
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
Trans temp porb
Hello I have been unsure as to where to put the trans temp sening unit . I have placed a few post but am unsure as to what to do. I pulled this response from ATS on where to put the sending unit . Dose any one agree whit this and if not tell me where you put it and how. Thank you Steve from AST-
We do not tap the line because it contains 'converter charge oil' which reads
very hot. It goes from there to the cooler and then back to the valve body
(which is what the critical components live off of). The servo is a good point to use but not as accurate and responsive as the pan. Even with +4 we recommend changing at 20k to 25k.
We do not tap the line because it contains 'converter charge oil' which reads
very hot. It goes from there to the cooler and then back to the valve body
(which is what the critical components live off of). The servo is a good point to use but not as accurate and responsive as the pan. Even with +4 we recommend changing at 20k to 25k.
Thread
Thread Starter
Forum
Replies
Last Post
1985cucv
3rd Gen High Performance and Accessories (5.9L Only)
4
02-18-2010 02:03 PM
Richpwb
3rd Gen Engine and Drivetrain -> 2003-2007
2
08-15-2008 08:01 PM
djgaston
3rd Gen Engine and Drivetrain -> 2003-2007
5
10-30-2005 03:18 PM
live wire
24 Valve Engine and Drivetrain
1
07-21-2003 07:26 AM