what is the stock 48re output shaft goodfor? i hear 650 plus hp and guys are beating them and they wont break is this correct? thanks

 

I broke mine around 600.

 

man so 90 hp sticks tnt and a new turbo would be pushing it that sucks thats what i want to do? maybe i could get some 50 hp sticks and a 62/65 instead of a super b special

 

Just get an aftermarket output. They are not that bad, 7-800 bucks, and you can install it without dropping the tranny.

 

yeah but maybe i just wont end up going for the bigger hp route. im prolly somewhere around 430-450 right now. how did you end up breaking yours 4wd boosted launches?

 

Yeah... I had just got my new turbo installed about a week prior, took it out for a test run... 4x4 launch at about 10 psi... truck didn't even jump hard. I had the tranny, it just did not have a billet output.

Another thing... I was running 35's at the time, MT's. Those put a lot of strain on the output as well.

 

ah i see i hear of guys running 20 psi launches with 600 horse and they hold i guess it is just a matter of what shaft you got. maybe i wont build the thing idk. i was thinking of maybe getting a 62 65 and running some 50 hp sticks but then im like why not go all out? idk we'll see

 

I'm running close to 700hp and I launch between 12-15psi on a stock output...but I know my time is coming.

 

i wont be doing any launches the truck is a daily driver i think i will just run my stock output and if it breaks so be it. i dont think ill be over 550 thanks for the help though

 

As long as you are not retarded on it, and don't shock it, you'll be fine. I beat on my truck a little, burnouts and hard launches.

I know a few guys that are pushing a lot of power on a stock output. A lot of people say that keeping a stock output will save you intermediate.

 

ok i would rather save the intermediate than blow the trans up again whereas the output can be replaced witht he trans in. thanks for the reply

 

i am running 1000hp on a stock output.holding up fine so far...

 

Could be an exception to the rule, king.

 

lol it will hold till it doesnt,however i am running a 2wd truck and using wrinkle wall slicks.i am positive it wouldnt last a day in a 4wd...

 

yeah why is that? i wont be over 600 so i should be good hopefully!