Lrdchaos

I have the Rokktech sensor installed on my truck, I picked up a J\A mostly for gauges, but if I decided to run it on level 1 or 2(don't wanna strain the trans) would that be too much timing? I know I can listen to the rattle and probably tell, just want to get some opinions.

madhat

I did a DIY sensor mod and ran an EJ/A and did not have any problems.

Lrdchaos

That's what I was thinking...Thank you

madhat

No worries. On the flip side to this, if you stack it with another box that adds timing, you better hope that you can turn the timing off on one of them. I stacked my smarty with it, and the timing was so advanced, my truck almost shut off.

Lrdchaos

Well with the rokktech, I can set it back to stock.

madhat

I would not worry about that, but the edge does add a good bit of timing.

Just keep an ear out for it.

LongRanger

There is a list of controllers that can work safely with a Rokktech sensor on their website. Nothing like real world advice as provided here though.