Getting ready for tranny
#1
Registered User
Thread Starter
Join Date: Apr 2008
Location: Edmonton, Alberta
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Getting ready for tranny
Well its getting close to tranny time. Havent smoked trans yet but its only time. Dyno'ed truck and with Edge on 3 made 404Hp and 784Tq at the back door, high EGT's caused Edge to defuel dropping number on lvl 4-5. Still running stock drive line . I think a new trans is in the future for spring like it or not. Lookin for a shop in Alberta that is near in case of problems. Looking for some ideas from peeps in the area. Was over to NADP but didn't get a good vib from the guys I talked to. Thinkin of rebuild trans, VB, TC,Flex plate and deep pan. May think about billet input too. I tow around 12k and it is a daily work truck. Might hit the track aswell but I dont drive the snot out of it.
Thread
Thread Starter
Forum
Replies
Last Post
ROCKNRAM
Performance and Accessories 2nd gen only
8
12-03-2007 02:19 PM
BrianC
3rd Gen Engine and Drivetrain -> 2003-2007
7
10-15-2003 09:05 PM