edge juice w/ attitude
#16
Originally Posted by CTD23
For the probe..is it just a drill and tap type of deal..or do i have to weld a special threaded bung on the manifold?
#17
I acctually did alot of searching and its a toss up between disconnecting the turbo and using the shop vac, to just greasing up the bit and tap real good and then following the drillign with a magnet clean up....i dont know i might need to peice of mind to just drop down the turbo...
#18
you won't need to do any of that. I was very paranoid and did the following. just drill slow so you don't drop a tone of shavings in, grease the tap wile you are tapping the hole, vaccum it out when done, and for last piece of mind I had someone hold somethine over the tailpipe to increase backpresure when you start it before you put the pyro in.
for all of my worring and paranoia it worked out just perfect.
for all of my worring and paranoia it worked out just perfect.
#19
Registered User
Join Date: Feb 2006
Location: Concord, CA
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know if you can use just the Attitude with out the chip?
I have an 05, and don't want to spend the full 800 for the juice, but want gauges and like the clean look of the attitude.
I have an 05, and don't want to spend the full 800 for the juice, but want gauges and like the clean look of the attitude.
#23
Originally Posted by welndmn
Does anyone know if you can use just the Attitude with out the chip?
I have an 05, and don't want to spend the full 800 for the juice, but want gauges and like the clean look of the attitude.
I have an 05, and don't want to spend the full 800 for the juice, but want gauges and like the clean look of the attitude.
I think you can run the outlook by bullydog as a stand alone but
quadzilla is also working on a monitor and so is TS products. The quad monitors sound like it will have the best functionallity of the monitors.
http://www.tsperformanceproducts.com/new_product.asp
http://www.quadzillapower.com/produc...itor-1205.html
#24
I have the juice with attitude and it makes my truck more responsive with smooth power. I think edge should make a box so you can use the attitude monitor independently, that way when I go to the dealer, I only have to swap the box, and leave the attitude in the overhead.
Thread
Thread Starter
Forum
Replies
Last Post
5.0 Mustang Man
Performance and Accessories 2nd gen only
6
10-21-2008 02:50 PM
razor6
3rd Gen High Performance and Accessories (5.9L Only)
22
01-20-2006 03:43 PM
PThree
3rd Gen High Performance and Accessories (5.9L Only)
22
02-14-2005 11:11 AM
john@dps
3rd Gen High Performance and Accessories (5.9L Only)
19
12-30-2004 07:10 PM
Big Bob
3rd Gen High Performance and Accessories (5.9L Only)
12
12-24-2004 04:10 PM