Drilling CFM+ intake
#1
Registered User
Thread Starter
Join Date: Apr 2007
Location: Southeren NM
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
Drilling CFM+ intake
I'm looking at at water/meth injection system, and have a question about nozzels. Can I drill and tap the CFM+ intake? Or do I need to drill into the grid heater instead? I figure that I might need to change out nozzles a time or two, and want to make sure I can do it with the plastic CFM+ intake.
#3
Registered User
If you want to have ports, sell yours and buy a CFM+ with ports, or go to the grid heater with it. You surely don't wanna mess up and have a 300 buck piece of plastic sitting around!!!
Thread
Thread Starter
Forum
Replies
Last Post
soot shooter
Performance and Accessories 2nd gen only
35
01-24-2008 11:53 AM
jmccart
3rd Gen High Performance and Accessories (5.9L Only)
14
04-13-2007 02:08 PM
CTDowerTN
3rd Gen High Performance and Accessories (5.9L Only)
18
01-11-2007 10:16 AM
blackdevil
3rd Gen High Performance and Accessories (5.9L Only)
21
10-10-2006 03:14 PM
CTDowerTN
3rd Gen High Performance and Accessories (5.9L Only)
2
09-29-2006 03:46 PM