koondawg

They dont make on for our trucks. you can order a custom. Thats what I did last week. Worth every penny. My carrier bearing and middle u joint were toast. I pulled the trigger on a 1 piece. Can spin my 37 inch tires. No way I woulda before. Felt like my rear end lifted 2 feet off of the ground before. Now planted and smooth between *****. There are plenty of different places to arder one from. Doghouse diesel. Action machine will make u a 4" with 1485 AAM joints for about 600 or so. I went with driveshaft specialists because it was a little cheaper than doghouse. 855 shipped 5" with 1480 spicer u joints and yokes.

Mike Custer

i know this is beating a dead horse and a long shot from how old the post is. But for sure 2.5 inches? Cause i measured mine with 2inches taken off puts it in about the factory spot for the truck its meant to be in

400HP

If I were you, I would just go to the driveline shop and get one built. Take the truck to there and have THEM measure it as it is their business (and they can fix it if its wrong)

If you considering ordering a factory one and getting it modded, it will cost you more anyway and wont be as good as a custom build. Any good driveline shop can build one. I had one built a few years back. Although it didn't fix my problem, it did help a bit with launch shudder. I would still recommend getting one. Best of luck.