How to replace front U Joints? Home job?
02-05-2011, 01:09 PM
#1
Registered User
Thread Starter
Join Date: Feb 2007
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
How to replace front U Joints? Home job?
I have a 05 Dodge 2500 and my front u joints are showing play and beginning to click a bit. Is there a how to on this forum showing how to do this the right way? Special press needed? It is a bear to get them out? Thanks
02-05-2011, 03:22 PM
#2
Registered User
Join Date: Nov 2006
Location: Southern Maryland
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
There's a few threads on the 3rd gen forum referring to manual locking hub conversions and they delve a little bit into replacing the u-joints. The 1st Gen sticky has a very good write up on replacing the u-joints on the Dana 60. Even though it's a difference axle than our AAM 9.25", it's pretty much the same process. The only major difference is removing the unit bearings on our trucks compared to the individual bearings on the 1st Gen 60's.
Thread
Thread Starter
Forum
Replies
Last Post
BC847
1st Gen. Ram - All Topics
21
07-30-2013 08:48 PM
wmbthe4
1st Gen. Ram - All Topics
4
05-27-2011 04:38 PM
Joe Diesel
24 Valve Engine and Drivetrain
23
03-25-2008 07:39 AM
rjm022
3rd Generation Ram - Non Drivetrain - All Years
3
04-18-2007 09:44 PM
