Dodgezilla

If it was working perfectly fine before you did this then I would bet that you have knocked something loose or somehow messed up the linkage. My bet would be that your linkage is not adjusted properly...

smokinram99

my tranny isn't perfect, when cold shift hard from 2nd to 3rd or won't shift up for the first 5, 10 miles. I have pulled off the pan, change filter, rebolt pan..added oil. when I checked 2nd time I took a look at the sensors, the one on the passenger side, front trans(to engine) is a bit loose, if I take my fingers on it, it moves a bit(isn't firm), but don't know what sensor is that or if a bit loose is ok....
how can I check the linkage??

smokinram99

How to adjust linkage??

smokinram99

chenged vout the Speed Sensor on the Driver side of the tranny(external) on the trans tail...a little better when in temperature..
waiting for the governor solenoid and the other external sensor..
I have also re-changed the ATF, from Royal Purple fully synt to a semi synt ATF +3, but nothing changed.

smokinram99

next week I'll try replacing the Pressure Sensor in the pan and cleaning the 2-3 gear SHIFT VALVE. following ATSG manual
Is this a good job?? anyone done it??

rob

smokinram99

I've replaced the PRESSURE SENSOR in the pan but NO change...I still have my problem.. tranny wont shift into 3rd untill I drive for about 10 miles...then shift.... anyone can help me??

rob