01 24 valve hard to start
08-07-2006, 01:06 PM
#16
Registered User
Join Date: May 2006
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
no, its fairly simple, just take your time. Don't worry some much about the key coming out of the injection pump shaft, I had to pry it out with a pick when i got it on the bench just to see how easy it would come out (i also tried this with my other vp and it was the same).
08-07-2006, 01:08 PM
#17
Registered User
Join Date: Feb 2004
Location: TF, Idaho
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
VP44 Install
Priming, just bump the starter with #1 injector cracked until you get fuel, tighten then start.
Priming, just bump the starter with #1 injector cracked until you get fuel, tighten then start.
08-07-2006, 02:43 PM
#18
Registered User
Thread Starter
Join Date: Feb 2006
Location: Durham, NC
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by dctoner
VP44 Install
Priming, just bump the starter with #1 injector cracked until you get fuel, tighten then start.
Priming, just bump the starter with #1 injector cracked until you get fuel, tighten then start.
08-08-2006, 11:03 PM
#19
Registered User
Thread Starter
Join Date: Feb 2006
Location: Durham, NC
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
New Vp-44 went on tonight. Every thing seems good. The code is gone and it runs and starts fine. Going down to the gulf of mexico tomorrow to pick up a 29 ft boat...we'll see how it really does. 
Thread
Thread Starter
Forum
Replies
Last Post