Wont idle, new parts, why?
#31
Registered User
Thread Starter
Join Date: Jun 2009
Location: Davie County NC
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Oh I hope not, if I do hook up this line to inlet line on the filter and it is still doing it then is that pretty much obvious VE problems.........dead pump or could something like a peice from my shutoff solenoid be in there in a bad spot?
#34
Adminstrator-ess
Yeah, the pieces wind up in the delivery valves but it rarely causes any trouble. It would be isolated to one or two cylinders anyway, not the sort of trouble you are seeing.
#35
Registered User
Thread Starter
Join Date: Jun 2009
Location: Davie County NC
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Ok well I hooked up a line to inlet tube to the filter and it still would not crank after I bled the injectors............
Does this sound like an air leak still or a bad IP, and are there anymore tests I might could run........?
Thanks as always
Does this sound like an air leak still or a bad IP, and are there anymore tests I might could run........?
Thanks as always
#39
Registered User
Join Date: Apr 2007
Location: Piedmont of NC
Posts: 393
Likes: 0
Received 0 Likes
on
0 Posts
#40
Registered User
Thread Starter
Join Date: Jun 2009
Location: Davie County NC
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Haha naw, IP is done. I hooked a rubber gas line directly to the low pressure inlet and it didnt change the outcome at all......but on a positive note im stayin with a buddy in TN whos got a shop soooooo I see the light at the end of the tunnel
#43
Registered User
Thread Starter
Join Date: Jun 2009
Location: Davie County NC
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Ahh! I just put on the new IP and it still wont run! I followed the videos in the sticky and got it all done, im gettin fuel to the injectors but it still wont run!
Please help!
Please help!