Pics sportring new paint..
#16
Registered User
Thread Starter
Join Date: Feb 2006
Location: West Jordan, UT
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by rlyons
Now how about some cool stacks?
So until I get some $$ and can be assurred that I can do it so as to not raise the noise level, I think it will probably remain the same.
Rich
#18
Registered User
Thread Starter
Join Date: Feb 2006
Location: West Jordan, UT
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BRUISER
Very NIce.. any pics of inside the cab showing walk through into back??
Looking from passenger side of the sleeper. The walls are upholstery fabric with a little padding pulled tight over 3/8's inch plywood. The fabric and plywood secured with 1.25" stainless screw with a finish washer. The sleeping pad is on a 3'' mattress puchased to fit in the sleeper.
Looking from center front at the crawl through.
Next two pictures showing how the crawl though was upholstered.
I padded the crawl through and it is sealed with an accordian boot. It does a nice job of limiting noise thru the back.
The sleeper is insulated with R13 which keeps it cool in the summer and warm in the winter. I haven't hooked up the sound to the sleeper but probably will in the near future. The original interior also had a forced fresh air vent that I am debating on putting back in. In the 15 years of history of the truck there has only been a few times it has ever be turned on. Usually the door vents are adequate.
Thanks for the interest,
Rich
#19
Registered User
Thread Starter
Join Date: Feb 2006
Location: West Jordan, UT
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
One other thing is that the lower compartments have become tool bins on either side with about a 6'inch communicating space all the way across...
Rich
Rich
#21
Registered User
Thread Starter
Join Date: Feb 2006
Location: West Jordan, UT
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BRUISER
Very nice job on the inside...
Oh by they way you have any pics of the back of truck now that it is done??
Oh by they way you have any pics of the back of truck now that it is done??
The flat bed is old and has survived a few trucks. Due to the nature of abuse the bed gets, I just roll white rustoleum paint onto it periodically. Seems to match ok and it is easily available.
Rich
Thread
Thread Starter
Forum
Replies
Last Post
mullishacrew
1st Gen. Ram - All Topics
4
03-19-2012 09:05 PM
easinc
3rd Gen High Performance and Accessories (5.9L Only)
7
03-16-2011 03:25 PM
st.rodder2
3rd Generation Ram - Non Drivetrain - All Years
23
12-17-2008 10:47 AM
RJOS
3rd Generation Ram - Non Drivetrain - All Years
4
05-27-2007 10:19 PM