Just making sure I have every thing listed that I will need. One nv4500 bell housing an bor the fly wheel for a new bearing. Cut a hole in the floor 4.5 inch's back and shorten the drive shaft 6.5 inch's and buy an nv yoke. Also a new cross member and sifter. If I have missed some thing let me know I would also like so imput from some one who has already done this. Good bye Getrag Thanks TBoling

 

Do you have the newer style adapter plate to allow the nv bell housing to bolt up? I think they're different from the 'rag.

 

from what I have read if you goto the newer style bell you will also need a 2nd gen starter, clutch throwout arm, and clutch slave assembly.

 

the bell housing will bolt up fine and the starter will also work as for the clucth just change the pilot bearing. An change the clucth hub no big deal.