A good partner for an S300 62/65/12? (compound turbos)
#17
Registered User
The 3b, hx60 and your run of the mill S400 will have a T6 flange. You can get the S400's in a T4 also. I've got an idea for a set of twins, but not sure how it would work. I think it would be similar to the BD tow set up. I'm thinking an he351 over a John Deere 173157.
The 173157 uses a 7-blade Extended Tip compressor wheel w/ 66mm inducer & 91mm exducer rated at 82lb/min. 4" Ported shroud Inlet, 3" outlet compressor housing. Turbine side is a 79mm inconel turbine wheel on a 4340 steel shaft. It uses a .91 A/R T4 twinscroll turbine housing" <- copied from another site.
This setup should spool lighting fast and more then cool the 450-500 RWHP the ve is capapble of. And yes I know the VE is capapble of more, but that seems to be the target range for most.
The 173157 uses a 7-blade Extended Tip compressor wheel w/ 66mm inducer & 91mm exducer rated at 82lb/min. 4" Ported shroud Inlet, 3" outlet compressor housing. Turbine side is a 79mm inconel turbine wheel on a 4340 steel shaft. It uses a .91 A/R T4 twinscroll turbine housing" <- copied from another site.
This setup should spool lighting fast and more then cool the 450-500 RWHP the ve is capapble of. And yes I know the VE is capapble of more, but that seems to be the target range for most.
Thread
Thread Starter
Forum
Replies
Last Post
dditt0635004x4
3rd Gen High Performance and Accessories (5.9L Only)
13
02-07-2007 12:36 PM
Robert Venable
Performance and Accessories 2nd gen only
34
12-11-2003 03:17 AM