Flat fender Power Wagon 12v Cummins VE
The following users liked this post:
gyman98 (02-20-2017)
#77
Registered User
Thread Starter
Thanks Brian, I will install that clip in the garbage pail then, now that i know it isn't needed and I didn't miss anything
#78
Registered User
Join Date: Dec 2010
Location: Land of the Toxic Avenger
Posts: 6,789
Received 1,647 Likes
on
1,120 Posts
Love the truck and the progress...
But I'm sure you're already aware of this....
But I'm sure you're already aware of this....
#79
Registered User
Thread Starter
The following 2 users liked this post by gyman98:
mknittle (02-20-2017),
thrashingcows (02-20-2017)
#80
Registered User
fantastic work
#82
Registered User
that floor looks fantastic. you can tell the work that was put into it.
The following 2 users liked this post by Blue Goose:
gyman98 (02-26-2017),
thrashingcows (02-25-2017)
#83
Registered User
Thread Starter
Not a whole lot of visual progress but a bit of progress regardless. Test fit the transfer case then removed and finished the floor. Set the valves in the engine while the cab was off. Modified a advance adapters 4wd shifter bracket just need to build a new shifter now. Started test fitting the seats. Finished the rear air bags. Lots of loose ends to tie up still
Wanted to buy new box sides from tisdale coach works but they are just to far out of my budget so with my newly learned sheet metal skills (?) I'm going to try and build new sides.
Wanted to buy new box sides from tisdale coach works but they are just to far out of my budget so with my newly learned sheet metal skills (?) I'm going to try and build new sides.
#84
Registered User
Thread Starter
The following users liked this post:
Blue Goose (03-06-2017)
#85
Registered User
I just voted for your crewcab om LMC's march mayhem page.
The following users liked this post:
gyman98 (03-07-2017)
#86
Registered User
Thread Starter
#87
Registered User
The following users liked this post:
gyman98 (03-07-2017)
#90
Registered User
Thread Starter
Been hammering away little by little on the power wagon whenever I get a free moment. Gave my buddy some bud light to use his large computerized brake and shear and got the box sides bent into shape. Need to cut and bend the wheel openings yet as well as put the pipe on top. Also sheared the pieces needed to bend the stake pockets up which I can do on my brake. Finished the 4wd shifter and cut the floor open for that. Made a centre console modelled after a Tuffy Jeep model I found online.
The following 3 users liked this post by gyman98: