dyno #s whats yours?
#16
Registered User
Join Date: May 2006
Location: Brighton CO and Cheyenne WY
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
Corrected or uncorrected hp? I see your in Idaho. Dynojets usually have software that automatically correct for a naturally aspirated engine. When I run on dynojets at this elevation (5200 ft) they usually correct for about 20% which makes mine dyno at 550+. Good numbers anyway.
#23
Registered User
Thread Starter
Join Date: Nov 2006
Location: NAMPA ID.
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
banks big head is a waste gate actuator that i think has a larger spring in it, it was already on the turbo when i got it. not exactly sure what it does(can anybody give the details) heres a full page sheet horse power looked pretty flat till about 2800 but tq started dropping pretty hard at 2000. this is my first diesel engine ever only had it for two months so im kinda learning as i go. as far as water meth if i can build my own setup i will probobly do it. the odd ball gov spring was kind of an accident. it definetly deosnt need it
#28
unfortunately stomp, i'm not holding much. put down 443/1000.9. got the wastegate actuator to do it's thing though. i'll see if i can't get the sheet up. definitely made a difference. only got to about 50 psi this time. swapped the old 16" rims on. i think there just wasn't enough load or something. tons of smoke, blah, blah, blah.
#29
Registered User
Thread Starter
Join Date: Nov 2006
Location: NAMPA ID.
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
#30
Registered User
Thread Starter
Join Date: Nov 2006
Location: NAMPA ID.
Posts: 71
Likes: 0
Received 0 Likes
on
0 Posts
unfortunately stomp, i'm not holding much. put down 443/1000.9. got the wastegate actuator to do it's thing though. i'll see if i can't get the sheet up. definitely made a difference. only got to about 50 psi this time. swapped the old 16" rims on. i think there just wasn't enough load or something. tons of smoke, blah, blah, blah.