Cooling system issues....
#1
Cooling system issues....
Hey guys, longtime lurker here. Here is one for you cooling system experts:
1991, non-ic, all stock, except the full power screw is turned in and the fuel pin is rotated. The truck all of a sudden started getting hot, like the thermostat was stuck closed. It would puke coolant out of the overflow bottle, and slowly get hotter on the temp gauge. So I changed the thermostat, and it still does the same thing, slowly warms up, and starts to boil in the overflow tank. System was flushed about 6 months ago, and coolant is clean. Any ideas?
1991, non-ic, all stock, except the full power screw is turned in and the fuel pin is rotated. The truck all of a sudden started getting hot, like the thermostat was stuck closed. It would puke coolant out of the overflow bottle, and slowly get hotter on the temp gauge. So I changed the thermostat, and it still does the same thing, slowly warms up, and starts to boil in the overflow tank. System was flushed about 6 months ago, and coolant is clean. Any ideas?
#2
Administrator
Did you let all the air bleed out of the system? Was the radiator full of crud when it was flushed out? Is the water pump pumping? If so, maybe the radiator is all plugged up, which is one of the reasons that I run 100% anti-freeze...Mark
#3
Is there a petcock or something to drain the radiator? How can I bleed air out of the system if that is the issue? The water pump is dry, it's not leaking From the pump. I personally did not flush the system, it was done when the engine was rebuilt 8 months ago.
#5
Administrator
There is a petcock on the lower drivers side of the radiator. Try draining enough from the rad to see the tubes inside. Sometimes you can see that there is corrosion clogging the tubes. If they are clear, check to see that both rad hoses are pressurized, when it is at operating temp, if not, the thermostat may not be opening. If there is no pressure, or you cannot see the water flowing in the rad, at operating temp, the pump may be bad. If you did not just do the flush, air is probably not the problem...Mark Also, is the front of the rad blocked by bugs or other debris?...
#6
Registered User
Join Date: Mar 2011
Location: Palo Cedro, CA
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
There is also an air bleed plug above the thermostat housing.
Check on a cold start, feel your upper hose, if the cooling system builds pressure immediately, you have a head gasket leaking gasses into the cooling system.
Check on a cold start, feel your upper hose, if the cooling system builds pressure immediately, you have a head gasket leaking gasses into the cooling system.
Trending Topics
#9
Registered User
Could be the T-stat was installed wrong. The BB could be in the wrong position causing fluid to not enter the motor for pre-cycle. It should be south so that coolant can bypass it at all times. You can feel the hose let go when you rev it up. If it stays hard then your T-stat is having issues.
#10
Administrator
It is a very simple system, go down the list of things it can be, simplest first, until you find the culprit. Check that t-stat is working, hoses are good, pump is working, radiator is clean, inside and out, and work your way to the more complicated, less common problems, like pressure problem. It doesn't have to be a guessing game, just be systematic...Mark
#11
Administrator
Also, air in the system, something common and simple, can cause your symptoms...Mark
#13
Administrator
#15
Administrator
While that is unanimous, it still is better to rule out the basics first. I put head gasket at the end of the list to check, but I'd check it after I ruled everything else out. my opinion...Mark