Dlowkes7

I recently bought a Meyer 7.5 plow to put on my w250, but there are a couple parts that i am missing. The lower vehicle mount. I was told i was basicly thick angle iron with a couple tabs to pin the plow a frame too. I was basicly wondering if any of you with an older meyers plow could take a couple pics of the vehicle side, so i can reference them when i get the piece built.

Trebor

Where are you located? I gave away the last I had off to a friend and have another setting here on an older truck.

Dlowkes7

Central Massachusetts.

Trebor

Well that would be a bit of a drive for a free part. I'd imagine you aren't planning any trips to the Pittsburgh area? If I have a chance I'll pull the grapevines off it and see about getting a few dimensions. This plow frame is the older style that has the angle bent around 180 degrees at the top, correct?

TIMMY22

Dlowkes7

TIMMY22, do you have a pic of that, but with the camera almost on the ground for the under side?

TIMMY22

Sorry, sold off that Meyer plow setup. Put a Fisher Minute mount 1 pushplates on the old girl now.

What exact part are you referring to? Bumper ears?

JustRamIt91

I'm buying one this weekend and i'll be able to get pictures then, if nobody else has.

Just wondering....

if u drive around with a plow on, are you still required to have a front bumper on?

rustydeeretech

i have one on my truck ill take a pic in the am

Trebor

In Pennsylvania, the answer is yes because the plow is detachable. Also, when in doubt check with your local state inspection guy, the one who physically does the inspection.

Buddy Stewert

In yellow does this help

Trebor

Well I went out today to get a few measurements and was surrounded by a small swarm of bees nested in the ground right in the area where I need to get into and lay down to measure.

Dlowkes7

Wow I havent seen bees in my neck if the woods for about a month now. Too cold for them. I have been plugging in my truck for the past week at night and its amazing having instant heat.