6.7L exhaust manifold fit on a first gen?
#1
Registered User
Thread Starter
Join Date: May 2005
Location: Katy, TX off north Mason Road.
Posts: 2,088
Likes: 0
Received 0 Likes
on
0 Posts
6.7L exhaust manifold fit on a first gen?
Just looking at some manifolds and really like the looks of the EGR ports on the newer exhaust manifolds. Does anyone know if it will bolt up to a first gen or 12v head for that matter?
The EGR ports would make for a very clean and simple WG setup! So for an application like mine where lightning spool is a must I could run 2 external gates to bleed off the excess drive pressure. One set for about 50psi, and the other for runs with nitrous set to open if it excedes 55psi boost.
Just thinking out loud, even if its a silly thought.
The EGR ports would make for a very clean and simple WG setup! So for an application like mine where lightning spool is a must I could run 2 external gates to bleed off the excess drive pressure. One set for about 50psi, and the other for runs with nitrous set to open if it excedes 55psi boost.
Just thinking out loud, even if its a silly thought.
#2
Registered User
I remember reading somewhere about someone doing something similar with a 5.9L 3rd gen manifold on a 12 valve that needed the turbo drop location for installation in a chevy. From what I remember they blended the manifold do the inlet was more rectangular vs round.
Thread
Thread Starter
Forum
Replies
Last Post
93DodgeW250
1st Gen. Ram - All Topics
9
08-24-2007 05:42 PM
GR40RCapri
3rd Gen Engine and Drivetrain -> 2003-2007
7
11-29-2006 10:14 PM
BrianW250
1st Gen. Ram - All Topics
4
04-08-2006 01:56 AM
BrianW250
Performance and Accessories 2nd gen only
5
04-08-2006 01:26 AM