some questions about the dana 60 and CAD
#1
Registered User
Thread Starter
some questions about the dana 60 and CAD
Is the 4WD system in these trucks supposed to include an open differential in the front? Ive got the 8800GVWR version and Im pretty sure theres no LSD in the front. Is it possible to add one?
looks like my CAD is screwed up somehow. Had a bang under there when shifting and assume it didnt engage 100% and popped out. if I engage the collar by hand and spin the wheel I can see the load move the collar up a little. Maybe its worn? The splines on the differential side axle stub are a little beat up from the collar too.
Ive seen some folks use a solenoid to drive the CAD fork, is there a kit somewhere?
looks like my CAD is screwed up somehow. Had a bang under there when shifting and assume it didnt engage 100% and popped out. if I engage the collar by hand and spin the wheel I can see the load move the collar up a little. Maybe its worn? The splines on the differential side axle stub are a little beat up from the collar too.
Ive seen some folks use a solenoid to drive the CAD fork, is there a kit somewhere?
#2
Registered User
Join Date: Sep 2006
Location: Hardinsburg, Indiana
Posts: 283
Likes: 0
Received 0 Likes
on
0 Posts
I have seen a kit on ebay for like $160 before, and I think its the one you are talking about. Not to sure about it because I've never done it before myself just read it on here somewhere I think but I cant remember where?
Thread
Thread Starter
Forum
Replies
Last Post
Diesel-Dan
24 Valve Engine and Drivetrain
13
11-23-2010 04:17 PM
Ramdriver15
12 Valve Engine and Drivetrain
6
10-29-2008 08:45 AM
MJDiesel
12 Valve Engine and Drivetrain
2
10-17-2007 08:40 PM