I need to borrow,rent,lease or buy a KDP jig, I don't need the
whole kit. Just the Jig.
P.S. How do I get in touch with Danelle ?
CA chapter pres. right ??

Thank You All for your support.

 

If you email me at:

rhanson117@aol.com

I can email you a name of a guy in idaho that builds/sells kits. I am sure you could just get the jig from him.

I just CRS about how to contact him, and all my info is at home.

Harold Bowers (Cubby) is his name.

 

You are better off doing the tab method.You never know how far the pin is out or gone!

 

I am in Norcal.

Also, the jig that is referred to available from Idaho is the one that I have. It allows you to pound the pin back in place.

It is not a bad job. A couple of hours at most.

 

I would like to fix my KDP to!

Bob does the one you have drill though from the front?

 

It comes in at an angle.

 

We did a bunch of KDPs with thie jig from idaho this weekend. We had 65 trucks here at one time. Three of the KDPs were out somewhat, and with care, we got all three back in, now permanently.

I will not get into an arguement over tab vs. pinning, to each there own. But, I will say that this jig is excellent.

 

About how much does this jig cost?

 

When I bought my jig kit, it was well under 100 bucks. Here is his email:

rvhvnfn@juno.com

Its a good kit, and has everything you and your buddies need to pin the KDP, except for the fan wrenches...I think he may even be able to include those, now.