Clutch suggestions...moderate mods soon, twins later...
#16
Ok if you say so hotmopr.
His name is Tomeygun on TDR. Here is a couple of quotes
I have the same clutch - MU13.125- OFE...
I know its crazy, buts it holds 600hp on the street... Only slipped when asked to hold a 4wd - 2nd gear launch from 2500 rpms...
I give this clutch a big thumbs up for quality, Althought I would go with the higher plate load thats now available...
Here is what is done to his rig 2003 3500 QUAD CAB,SO/5-SPD, TST/EZ, SLEDPULLER 66, SBC MU13-1.25 CON OFE, 5" STACKS , GOT FLUX ?!, DPP Fuel pump, CP3 modified by FLOOR-IT Diesel! -- STL, MO DYNO Day Video!
DYNO Runs (W/ Video) <-- (604.8hp!)
Also numerous others over 500hp with the OFE holding fine. Consider its rated at 450/1000 that is awesome.
Kurtis
His name is Tomeygun on TDR. Here is a couple of quotes
I have the same clutch - MU13.125- OFE...
I know its crazy, buts it holds 600hp on the street... Only slipped when asked to hold a 4wd - 2nd gear launch from 2500 rpms...
I give this clutch a big thumbs up for quality, Althought I would go with the higher plate load thats now available...
Here is what is done to his rig 2003 3500 QUAD CAB,SO/5-SPD, TST/EZ, SLEDPULLER 66, SBC MU13-1.25 CON OFE, 5" STACKS , GOT FLUX ?!, DPP Fuel pump, CP3 modified by FLOOR-IT Diesel! -- STL, MO DYNO Day Video!
DYNO Runs (W/ Video) <-- (604.8hp!)
Also numerous others over 500hp with the OFE holding fine. Consider its rated at 450/1000 that is awesome.
Kurtis
But not very good when side-stepping for a burnout
#18
Registered User
Join Date: Jun 2002
Location: dfw texas
Posts: 1,771
Likes: 0
Received 0 Likes
on
0 Posts
my fe would not hold at 400 rwhp if i tried to speed shift. from 3rd to 4th at 4k or so it slipped every time. and would not grab till i let off. ot held on the dyno fine and i even sled pulled with it.
Thread
Thread Starter
Forum
Replies
Last Post
dblack98
Performance and Accessories 2nd gen only
4
08-20-2009 12:32 PM